I thought that you could use a GFCI on a two wire set up, but you
couldn't add any down-stream outlets.
That is, that each 3 wire outlet needed to be a GFCI. I don't have my
code book here, but will check it
soon.
And, as someone already said, check with your local authority.
Peace,
Pat
Thusly spake Randall, On 6/2/2009 5:01 PM:
>> (It may be that if you're providing ground plugs other
>> than at the GFCI, you need ground between the GFCI and the new plugs)
>>
>
> ISTR the NEC didn't require this; but I sure wouldn't want a house that was
> wired that way.
>
> In effect, not having the safety ground connected back to the GFCI would
> mean that an appliance plugged into a new plug could have a short between
> hot and the case (safety ground) that would not be detected until someone
> touched it and completed the circuit. Call me old-fashioned, but I just
> don't trust a GFCI that much.
>
> -- Randall
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pat@hornesystemstx.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
>
>
>
--
Pat Horne, Owner, Horne Systems
(512) 797-7501 Voice 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|