Actually my reply shown below was associated with an earlier
post that had suggested a nibbler, either manual, electrical
or air powered. Your irvansmith item is just about
exactly what I was referring to. Possibly the earlier
post was only sent to me directly and not to the group.
At least that's my story and I'm sticking to it.
Steve........thanks for pointing me in this direction.
Your help is appreciated.
Thanks.
Steve Hammatt
Mount Vernon WA USA
----- Original Message -----
From: "Steven Trovato" <strovato@optonline.net>
To: "Steve Hammatt Mount Vernon WA USA" <gsteve@hammatt.com>; "Shop
Talk" <shop-talk@autox.team.net>
Sent: Tuesday, March 24, 2009 8:30 PM
Subject: Re: [Shop-talk] making radiused corners on sheet metal
>I guess I don't understand. This is a 3/8 round die for this tool.
>
> http://www.irvansmith.com/scart/round-cutting-unit-p-1103.html
>
> There are many other die choices, bigger and smaller. Why doesn't
> this meet your requirements?
>
> -Steve
>
> At 08:48 PM 3/24/2009, Steve Hammatt Mount Vernon WA USA wrote:
>>No (I think), what I'm looking for is to cut off an outside
>>point from each 90 degree corner. The radius will be
>>less than 3/8" and it must look perfect. I believe what
>>you're referring to is a hand nibbler more suitable for
>>large radius work. Maybe I'm looking for a notcher
>>capable of radiusing small corners? Any possible source?
>>Thanks.
>
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.11.26/2020 - Release Date:
03/24/09 09:19:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|