Morse makes a similar product called the Metal Devil saw blades. There are
a ton of videos of them cutting all kinds of metal (plate, unistrut, angle,
etc) on their website.
-Paul
On Jan 9, 2008 8:00 PM, john niolon <jniolon@bham.rr.com> wrote:
> I don't know if this qualifies as a "tip or trick" or more of a tool
> recommendations.
>
> Back a few months ago a member of the Ford site I frequent told me about
> a
> dry cut metal saw blade that could replace an abrasive blade in a chop
> saw.
> They can handle the chop saw speed. They are made by Bullet Industries.
> The
> 14" model (chop saw size) is about 50 bucks. I ordered and finally got to
> install tonight.
>
> clamped in a piece of 2x2x<" angle iron and dropped the blade down.. It
> almost fell thru the metal !!! If you've used a chop saw you know about
> pressure on the blade and the mess it makes. Only the lightest pressure
> is
> needed...just let the blade do the work. It's like a hot knife thru soft
> butter.. The output was very fine chips of metal that pretty much stay
> close to where you're cutting and not floating around in the air and up
> your
> nose like the abrasive dust.
>
> I can't say anything about longevity yet, but for speed of cut and ease of
> cut this is the best I've found... check them out below. If you do a lot
> of
> fabricating and cutting... this really seems like the way to go....
>
>
>
>
>http://www.bulletindustries.com/catalog/product_info.php/cPath/99_144/products_id/784
>
> john
>
> All I ask is a chance to prove that money can't make me happy.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as parkanzky@gmail.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|