A bit late but I have one of these
http://www.grizzly.com/products/Mini-sheet-Metal-Cutter/G9947 for cutting
sheet metal and it works well. I used it all the time. One of the best $20
purchases I have made in a long time.
-g
On 12/29/07, Randall <tr3driver@ca.rr.com> wrote:
>
> > Has anyone tried out one of these nibblers ?
> > http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=46061
> >
> > Does it really use that much air ? Or did the ad writer goof
> > and quote the SCFM number ?
>
> Just wanted to report : I picked up the nibbler and used it; worked great
> for what I needed to do (which was to enlarge a 5" opening in an existing
> flat-sided air duct to 8"). Didn't try to measure the air consumption,
> but
> it must be a misprint; worked just fine with my little 110v 25 gal air
> compressor. Seemed to use even less air than my "4 cfm" die grinder, so
> I'd
> guess maybe the number on HF's site was in SCFM.
>
> Thanks again to everyone who responded.
>
> Randall
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as wmgilroy@gmail.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|