> I would like to have 3 lights controller by 2 motion sensors.
> The configuration is one light on the front of the house and
> two around a corner on the garage. I would like all 3 to
> come on when there is motion at the front door or around the
> corner by the garage. So, what I need are 3 lights the can
> be controlled by 2 motion sensors. I am not against running
> wire, but I have cannot find what I would need to create this setup.
>
> As for the lights with built in sensor there are 2 problems.
> All three lights will not come on at once and my wife does
> not like the style of the lights with built in sensors so
> that solution is a non-starter. Any ideas?
>
> Thanks,
>
> Bill
Bill, sounds like a perfect application for X10 control. I know some of the
lights with the built in sensors also have built in X10 transmitters. You
can check it out at http://www.worthdist.com/ or smarthome.com too.
I've been controlling quite a bit for over 10 yrs using X10. It's not
perfect, but then it's not too expensive and pretty straightforward to
troubleshoot.
Gordie Bird
'62 MGA
'67 MGBGT
|