The goal here is to 30x60in surface, hinged off the back of my Vidmar
cabinets. This is about all I have room for, and it needs to be able to
fold out of the way. My thoughts are as follows:
a) A piece of welded boiler-decking e.g.
http://www.mcnichols.com/products/bargrating/welded/ as the cutting
surface. It should be rigid enough and flat enough, and just about
manageable on the weight front.
How quickly should one expect a cutting table to get chewed up?
b) Something else that would lay on top of it as the welding surface,
maybe a sheet of 14ga steel.
Any better alternatives? I'd think it has to be cheap enough to replace
every so often, so stuff like sheet copper starts to get prohibitive.
John.
|