The adjustments are actually more like "cut in" and "range between on and off".
Adjusting the cut in screw will move the cut out pressure the same amount.
When my last pressure switch became very erratic, it turned out that the small
restrictor orifice below the switch had gotten scaled up. Replacing the
restrictor cured the erratic behavior.
Ken (16 years on well water) Landaiche
-----Original Message-----
There are two adjustments, one for cut in, one for cut out. My memory doesn't
remember enough to describe it to you, but I figured it out by observing.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|