RE: angle grinder?

["Mullen, Tim" <Tim.Mullen@trw.com>]

Ralph Forsythe [mailto:rf-list@centerone.com] wrote:
>
> I'm not sure if this is the right tool for the job...  <...> 
> I'm thinking one of those angle grinders with a good wheel on 
> it could essentially "grind away" the weld.

I'd use a cutoff tool (high speed air tool with a cutoff wheel) 
<http://www.harborfreight.com/cpi/ctaf/Category.taf?CategoryID=331&pricetype=>
to cut the bracket off, then the grinding heel to remove (grind 
off) the rest.

It would be a lot quicker.  And give you a good excuse to buy an
air compressor if you don't already have one...

Tim Mullen

Chantilly, VA

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk