> > Stick the short end of a 1/4" or larger allen wrench in the chuck and
> > tighten it down. Next, get a soft hammer or piece of wood and hit the long
> > end. This will loosen the chuck so you can remove it by hand.
I've seen this done with an impact gun. Put the drill in a
vise. Clamp a 1/2" or 3/8" drive hex bit/key in the chuck,
and use the impact gun to loosen it. Works like a charm!!
:)
If you don't have a hex bit set, any 1/2" or 3/8" drive
screw driver bit usually has a hex shaft that you can clamp
the chuck onto. Good Luck!
Scott Whitehead
88 IT-E Mustang GT
98 F-150 Flare Side
http://www.ameritech.net/users/swhiteh3/home.htm
|