> 3. "Maximum"/"Minimum" rocker switch
> 4. "1"/"2" rocker switch
>
>Any ideas on the purpose and use of switches 3 and 4?
The controls sound just like the ones on my Daytona "Pocket MIG". Those two
switches would then give you four possible power settings. I.e.
Minimum + 1
Minimum + 2
Maximum + 1
Maximum + 2
I've used the lowest setting for thin sheet metal, and the highest for 1/4"
angle iron. If this is not the function of your switches, and they instead
cause a thermonuclear explosion, then I never said anything and this is was
posted by a hacker who got into my account.
Lee M. Daniels Laboratory for Molecular Structure and Bonding
daniels@cryogen.com Texas A&M University
'74 TR6 '77 MGB "Damn the candles on the cake, crank up the rock & roll
and slide the Triumph through the curves!" - TeriAnn Wakeman
|