Hope this isn't in a FAQ somewhere.
I just purchased a 14" 4200 RPM abrasive cut-off saw. I don't do wood much
but it has me intrigued, is there any reason that one could not bolt an
appropriately sized and rate circular (wood) saw blade in place and whack
up 2 x 4s?
The arbor hole on the steel blades are smaller than the one on the abrasive
units, but that's easy to fix.
Any thoughts or experience?
TIA
Whatever ya do, don't turn your back on a race car . . . and never lift
aka Rags another Cal Club flagger
Rags@consultantalliance.com
|