welders

["W. R. Gibbons" <gibbons@northpole.med.uvm.edu>]

I have a Lincoln SP-100 mig welder, which I like very well.  It does not 
do particularly well when the thickness of the steel is 0.100 in or more, 
but it is fine on sheet metal.

I suspect, however, that you meant the cheaper flux core wire feed 
welders.  I have no experience with them, but I have been told they are 
not as clean or easy to use as mig.

   Ray Gibbons  Dept. of Molecular Physiology & Biophysics
                Univ. of Vermont College of Medicine, Burlington, VT
                gibbons@northpole.med.uvm.edu  (802) 656-8910