each leaf changes differently.
when i pull a leaf or 2 the first small one gives about an 1-2" and the
next ones ...
if you want to lower-only remove 2 leafs. any more and you will find
yourself bottoming out especially in front-not good. ive bent springs
in half before..
if you want ti low-go big and spend the money on a reversed eye
monoleaf thats been constructed low. anything else is dangerous. and
yes-i did it before i knew better.
does this make me older now? =)?/
mark
>
> ------------------------------
>
> Date: Wed, 12 Apr 2006 22:07:51 -0400
> From: "Norm Donnelly" <normd@metrocast.net>
> Subject: [oletrucks] lowering rear end 1955 chevy
>
> I am lower the rear and want start by removing leaves from the
> springs. What
> is the effect of various combinations. ei say leaf 1 and 3= ??
> inches.
>
> TIA
> Norm D
>
> ------------------------------
>
> End of oletrucks-digest V2 #2647
> ********************************
>
>
>
nor-cal---------------------------http://customclassics.org
Tired of spam? Yahoo! Mail has the best spam protection around
|