In a message dated 2/23/00 7:25:27 PM Pacific Standard Time, BDober@aol.com
writes:
> Replaced a badly cracked stock exhaust manifold with Fentons, but want to
run
>
> the stock intake on the 235. Anybody have that setup and did you do
anything
>
> to duct hot exhaust like with the stock setup from the Fentons (construct
> some sort of block off plate under middle of intake) up to the old
intake?
> Also been suggested by others not to bother, that after a while it'll heat
> up
> anyway even though they are not physically connected like before. Any
> thoughts ideas appreciated
I'd be interested in this as well, also if anyone replies, please post
where you're at and the climate you drive your truck in too.
Thanks,
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|