| To: | oletrucks <oletrucks@autox.team.net> |
|---|---|
| Subject: | Re: [oletrucks] Break cylinder question |
| From: | "Terry S. Glines" <ace0027@attglobal.net> |
| Date: | Fri, 18 Feb 2000 22:07:48 -0600 |
Started not to mention this, but why not? =)
There is one method of bending tubes that I have used sevral times. Cut the
tube to length, then fill it good and tight with sand. Now you still want to go
slow and easy on tight corners, but it will keep the line from reaching that
dreaded "Crap! to far" point.
Terry & Ace
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|
| Previous by Date: | Re: [oletrucks] horn button, tcape |
|---|---|
| Next by Date: | [oletrucks] Oops! My 270's a boat anchor! (was happy update), CLLLSLS |
| Previous by Thread: | Re: [oletrucks] Break cylinder question, Bruce Damen |
| Next by Thread: | Re: [oletrucks] Break cylinder question, G. Simmons |
| Indexes: | [Date] [Thread] [Top] [All Lists] |