Our trucks used to have a crank handle as standard equipment, meaning you
should be able to start it by hand; right, Bob? That's pretty slow
cranking!!!
Tim '50 1/2t dlx
> -----Original Message-----
> From: Advdesign1@aol.com [SMTP:Advdesign1@aol.com]
> Sent: Wednesday, January 19, 2000 6:01 AM
> To: dkrehbiel@kscable.com; stewartk@mbnet.mb.ca;
> oletrucks@autox.team.net
> Subject: Re: [oletrucks] Starters
>
> >
> > > 1. When cranking how fast should I expect the engine to turn over?
> For
> > > example is one revolution of the fan blade per second about right?
> > >
>
> Try retarding the timing a few degrees with octane selector. Feel all
> connections for heat when cranking. Clean or replace any that get hot.
> Also
> make sure the ground is good especially if you just painted frame. Engine
>
> will loosen up after it is run. I've seen a starter use so much current
> that
> there is not enough voltage left for a good spark. Truck fires up as soon
> as
> i release starter.
>
> Bob ADler
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|