Jack, and everyone else who responded-
Thanks for all the info!
I think I got lucky and found a New Original Stock U-Joint assembly (for 3 spd
tranny only) complete - with front and rear yoke for $99 through The filling
Station. They have a good supply if anyone else is interested. The bearing /
seal kit is an additional $65. I hope this works and that I dont have a bent
driveline - the old yoke got pretty hammered, and I'm hoping the stress was
isolated by the front bearing...
Thanks again for all the ADvice!
Tom '49 3100 delux
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|