Does anyone know if the truck tool kit is available from any of the vendors?
Never seen it in a catalog.
Tom Caperton
'47 2nd 3100
-----Original Message-----
From: D. SLANEY <ppm@dlcwest.com>
To: tcape <tcape@weblnk.net>
Cc: oletrucks@autox.team.net
Date: Thursday, March 04, 1999 2:50 PM
Subject: Re: [oletrucks] Jacks and tire tools
>Tom, do you think such a kit exists complete somewhere in captivity, what a
>fine find that would make to complete a project.
>Regards,
>Don.
>----- Original Message -----
>From: tcape <tcape@weblnk.net>
>To: Brad Newman <bkn@cyberramp.net>; oletrucks <oletrucks@autox.team.net>
>Sent: Thursday, March 04, 1999 11:43 AM
>Subject: Re: [oletrucks] Jacks and tire tools
>
>
>>Brad, I'm taking this from the Chevy specs for my '47, but I believe it
>>applies for all AD models. (I have a little feeling someone will correct
>me
>>if I'm wrong!) The tools included with the 3100 were:
>> - jack...2,500 pound capacity, raised height = 15 1/2"...lowered
>height
>>= 6 1/2"
>> - tire changing iron....with RPO 273 (no idea what "RPO 273" means)
>> - wrenches....spark plug, wheel, open end (3)
>> - pliers...combination 6"
>> - screw driver....round shank...5 1/4"
>> - hammer....ball peen...10 ounce
>> - tool bag....cotton duck material (held all the tools).
>>
>>All the tools were stored under the seat.
>>Hope this helps.
>>Tom Caperton
>>'47 2nd 3100
>>
>>
>>-----Original Message-----
>>From: Brad Newman <bkn@cyberramp.net>
>>To: oletrucks <oletrucks@autox.team.net>
>>Date: Thursday, March 04, 1999 8:33 AM
>>Subject: [oletrucks] Jacks and tire tools
>>
>>
>>>A question regarding my 49 1/2 ton:
>>>Can anyone out there describe what an original jack looked like, plus
>>>where and how it was stored? Also wondering about the original tire
>>>tool.
>>>Would anyone know where a guy could purchase these?
>>>TIA
>>>Brad
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|