mgs
[Top] [All Lists]

Re: [Mgs] Mgs Digest, Vol 73, Issue 18

To: mgs@autox.team.net
Subject: Re: [Mgs] Mgs Digest, Vol 73, Issue 18
From: Allen Hess <allenhess@mgcarclub.com>
Date: Fri, 28 Jun 2013 14:36:13 -0400
Authentication-results: smtp02.rcn.cmh.synacor.com smtp.mail=allenhess@mgcarclub.com; spf=neutral; sender-id=neutral
Authentication-results: smtp02.rcn.cmh.synacor.com header.from=allenhess@mgcarclub.com; sender-id=neutral
Delivered-to: mharc@autox.team.net
Delivered-to: mgs@autox.team.net
References: <mailman.0.1372442401.24428.mgs@autox.team.net>
X_cmae_category: 0,0 Undefined,Undefined a=KvonDqueJGHIzwFqfYayOQ==:117 a=JcBjd7tT8SEA:10 a=1GtspROMyXkA:10 a=rgFOHuIoAAAA:8 a=yrpFIgZeHRUA:10 a=zOoktvdPAAAA:8 a=Xhio1hzW2_-c9zXLo9cA:9 a=CjuIK1q_8ugA:10 a=qeOVnMb4xrqNWELyBk0A:9 a=5bU24wgzwJ1HHidF:21 a=_W_S_7VecoQA:10
Smart -- just like a windshield.

Allen
On Jun 28, 2013, at 2:00 PM, mgs-request@autox.team.net wrote:

> You can't put the grommet in the panel first, because the nut on end  
> of oil cooler hose is larger and won't go through the grommet when  
> in the panel.  But it is easy when you know how.  Put the grommet on  
> the hose first (stretching the grommet to go over the nut).  Then  
> pass the nut and hose through the panel, bringing the grommet up to  
> the hole.  Wrap a string around the grommet in the groove 1-1/2  
> turns.  Pass the string through the panel hole.  Push grommet up  
> against the panel, and pull on the string.  As the string pulls  
> through it will pull the lip of the grommet through the hole, and  
> irt's done in a flash.
>
> Barney Gaylord
_______________________________________________

Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>