Hello fellow mgers.
I'm going to try to adapt another flywheel to my mg crankshaft in a devious
experiment that shall remain a mystery for now.
I would like to know the following.
1. Did the hole pattern remain the same throughout the MG life for the A
series engine?B
B B ( think thats the term. Motor used from mga through mgb)
2. what is the pattern of studs coming off the crankshaft that the flywheel
bolts too? ( i.e. 6X? )
3. Are there any other makes of car that have a flywheel that is
interchangable with this pattern?
Many thanks for all responses!
Eric "mad scientist" peterson
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|