I do mean the tiny fiber washer you mention, any idea where to get them, ?, a
friend mentioned that we could make them. I do have the plastic floats.
---- Max Heim <max_heim@sbcglobal.net> wrote:
> If by a gasket you mean a tiny fiber washer, yes. Although if you have the
> non-adjustable replacement plastic floats, you might have to eliminate the
> washer, or stack up two of them, to achieve the correct float height.
>
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the primer red one with chrome wires
>
>
> on 8/29/08 5:36 PM, Bernd at 1971mgb@cox.net wrote:
>
> > On the HS-4 carbs is there a gasket that goes on top of the Needle and
>Seat?,
> > on top of the threaded part of the Seat, it's located in the fload bowl.
>Moss
> > does not show one, on part number 373-626, item 33. I've heard that unless
> > there is a gasket in that location, gasoline can seep through. Confused as
> > usual.
> > 71 MGB
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as 1971mgb@cox.net
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|