Mike
I believe this will help you with removing the bearings:
http://mgaguru.com/mgtech/universal/ut108.htm
Always go to Barney Gaylord's site when you have an MGA question - the
answer is usually there. mgaguru.com
Rick
Webmaster for:
___________________________________________________________
http://www.mgcars.org.uk/namgbr - The North American MGB Register
http://www.mgcars.org.uk/mgcouncil - North American Council of MG
Registers
http://www.britishcarclub.net - The Suncoast Classic MG Club and Nature
Coast English Car Club
----- Original Message -----
From: "Mike Duvall" <duvallcom@sbcglobal.net>
To: <british-cars@autox.team.net>; "mgs mgs" <mgs@autox.team.net>
Sent: Friday, July 25, 2008 19:06
Subject: [Mgs] MGA front hub bearing removal
> How do I remove the bearings from the front hubs on an MGA? I assume
> each bearing pulls out the sleeve in the center prevents using some
> kind of puller. The only method I can think of is to get a punch on
> the inner edge and try to tap it out.
>
> Any better suggestions?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|