Ok, I am still working on the driver's side engine mount (LHD). I have come to
the conclusion that I need to remove the steering shaft
to get at it. I had purchased a bicycle wrench and could get it on the nut, but
I feel like it may be starting to round off a bit. So, out comes
the shaft, I guess.....
Am I correct in thinking that I need can remove just the shaft, and not the
entire rack?? It seems like if I unbolt it at the u-joint (which I have
done and am soaking with penetrant) and then remove the cap and nut at the
lower end, the shaft should just slide through the rack, right?
Dan D
Central NJ USA
'76 MGB Tourer - Driver - Engine Surgery In Progress...
'65 MGB Tourer Project - Yep, Still Is....
NAMGBR #5-2328
http://dans65b.blogspot.com/
http://dansautoblog.blogspot.com/
http://mywebpages.comcast.net/dibiase/Working_MG_Gallery.html
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|