| To: | mgs@autox.team.net |
|---|---|
| Subject: | Nylon bear/seal removal Midget Master Cylinder |
| From: | Jeremy Loukinas <Sunadmin@adelphia.net> |
| Date: | Thu, 31 Mar 2005 00:33:13 -0500 |
I am in the process of rebuilding my Midget master cylinder. 73 GAN5 car ... Once I removed the MC from the car I compressed the Spring and removed the Spirolox ring allowing me to see the Nylong Guide Bearing/Seal. I removed the Circlip but How do you remove this Nylon seal?? I am reading a Haynes manual and it says : Gently move the piston up and down in the cylinder bore to free the nylon guide bearing and the cap seal. when I do that my nylon seal does not move at all... Any suggestions? J |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: 73 midget tach cable driven?, ptegler |
|---|---|
| Next by Date: | Re: Pinholes in gas tank, Paul Hunt |
| Previous by Thread: | 73 midget tach cable driven?, Jeremy Loukinas |
| Next by Thread: | Re: Nylon bear/seal removal Midget Master Cylinder, Jim Leach |
| Indexes: | [Date] [Thread] [Top] [All Lists] |