Hi
Finally started getting the harness on my 68B Roadster back together and
sorted out.
The cable from the coil + that then loops at the rev counter and goes onto
the ignition switch was melted very badly and I replaced the entire section.
The problem I have is the little plastic tab thingy that makes the loop at
the rev counter. It is also quite badly melted and I don't think I will be
able to salvage it to loop the new cable around.
Are these things available and if so from where?
If they are not available, is there some other way I can create this loop?
Thanks,
Ross Bateman
British Sports Cars in South Africa
www.rcsa.co.za
____________________________________
This isn't life in the fast lane,
it's life in the oncoming traffic.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|