Folks at world,
Just trying to get new replacement dash cover stuck onto the steel base.
Question 1 - Are the MGB 77-80 dash switches smaller that the previous
dashes ? I measure hole in steel at 22mm by 30mm and ones I have been given
are bigger than that
Question 2 - There are four holes for switches are they hazard, heater,
wiper and lights ? But then light switch is on stalk yes?
By the way aligning the cover seems a bit of a sod as the moulding is not
A1 accurate.
Regards
Barrie
Barrie Robinson - barrier@bconnex.net
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|