mgs
[Top] [All Lists]

Re: Replacing Camshaft Steps

To: "Andrew B. Lundgren" <lundgren@byu.net>,
Subject: Re: Replacing Camshaft Steps
From: "mgamgb" <mgamgb@ihug.co.nz>
Date: Sat, 29 Dec 2001 18:56:00 +1300
"Question, in order to remove the Push Rods, must I remove the rocker
assembly?"



If its a standard MGB (with spacer springs), no need to remove rocker gear.

Proceed as if adjusting clearances, ie work on no 1 rocker with valve no 8
fully open.

Loosen adjuster screw all the way back, slide rocker sideways against spacer
spring and remove push rod for rockers 2 to 7.

For no 1 and 8, remove the split pin and washers, remove rocker.

Cheers  Ian f

///
///  mgs@autox.team.net mailing list
///  or try http://www.team.net/cgi-bin/majorcool
///


<Prev in Thread] Current Thread [Next in Thread>