To: | mgs <mgs@autox.team.net> |
---|---|
Subject: | Re: Dipstick Tube Installation |
From: | Bullwinkle <yd3@nvc.net> |
Date: | Tue, 04 Dec 2001 11:11:33 -0600 |
Bill: If the tube bent or collapsed while "tapping in" you could decrease the interference fit some by sanding the tube. Another way to prevent collapsing is to insert a rod into the tube which is the same OD as the tubes ID or sand. Sand is used interally sometimes in tubes to prevent their collapsing while bending tubing. Blake /// /// mgs@autox.team.net mailing list /// or try http://www.team.net/cgi-bin/majorcool /// |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Clutch Problems, Bullwinkle |
---|---|
Next by Date: | Re: Howdy!, Rocky Frisco |
Previous by Thread: | Dipstick Tube Installation, WCAMEYER |
Next by Thread: | Re: Dipstick Tube Installation, British Sportscar Center |
Indexes: | [Date] [Thread] [Top] [All Lists] |