I would think a Helicoil thread insert would be a better longterm
solution, if it's even possible in that location. I would be dubious that
JB Weld would hold given the small size of the threads (I assume you
aren't proposing to glue the carburetor body together).
Matthew Trebelhorn had this to say:
> Unfortunately, he damaged
>the threads in the carburetor body. It holds, but not tight enough to
>prevent
>leaks.
>
>Would something like JB Weld help seal this? Is it gas-proof? Or are there
>any other suggestions?
>
>Any thoughts appreciated,
>Matt
>
>____________________________________________________________________
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the red one with the silver bootlid.
|