I agree but if I switched the wires 180 then it would be ok, right?
Dereck
----Original Message Follows----
From: "Michael Lupynec" <mlupynec@globalserve.net>
To: "Dereck C" <derex39@hotmail.com>, <dcouncil@imt.net>,
<mgs@autox.team.net>
Subject: Re: 70 MGB no start after complete rebuild
Date: Wed, 16 Aug 2000 11:24:06 -0400
You are right about the offset slots, but the dist drive gear may
have been installed 180 out.
Mike L.
60A,67E,59Bug
----- Original Message -----
From: Dereck C <derex39@hotmail.com>
To: <dcouncil@imt.net>; <derex39@hotmail.com>;
<mgs@autox.team.net>
Sent: August 16, 2000 10:25 AM
Subject: Re: 70 MGB no start after complete rebuild
>
> Sorry, I changed the wires too. When you say remove the
distributor and put
> it in 180 the other way, there is only one way that the chuck
(proper term?)
> will line up on this model - the slots are offset. I was just
going to
> rotate the wires 180 degrees. Won't that work? Or should I
remove the
> distributor drive gear and reinsert it 180 degrees. Honestly, I
don't see
> how that would make a difference. If it does please please
enlighten
________________________________________________________________________
|