Yes,
I did this with my original wiring loom in the dash.
No problem if it's well soldered and properly done.
Good luck!
Cheers,
Hans
'71 BGT
> -----Original Message-----
> From: VSchus8282@aol.com [SMTP:VSchus8282@aol.com]
> Sent: zondag 19 december 1999 17:14
> To: mgs@autox.team.net
> Subject: Harness repair
>
> I just managed to melt wires on a new harness. The melt down occured at
> the
> ignition switch and going into the fuse box. White and Brown wires were
> involved. I am planing to cut and splice new wires using soldered bullet
> connectors and the standard connectors. Is this method of repairng the
> damage
> OK for this situation?
>
> Thanks, Vic
|