Another approach to this test, if you don't have a cable to sacrifice,
is to use the square-drive tip for deck screws, the kind you use in
electric drill for driving screws.. Around here, they are known as
"square drive" or "Canadian drive" tips. Hardware stores carry them.
Bob
On Fri, 07 May 1999 14:30:12 Barney Gaylord <barneymg@ntsource.com>
writes:
snip
>Since your old cable is shot anyway, clip a couple inches off the
>bottom
>end of the cable core, chuck it in your reversible drill, and use that
>to
>drive the tach with the drill in reverse at top speed (running
>counter-clockwise to match the sweep direction of the tach needle).
snip
>1958 MGA with an attitude
> http://www.ntsource.com/~barneymg
>
>
|