Clive Wheatley in the UK regularly supplies these (any many other conversion
parts) all over the world.
Clive Wheatley
The Garage, 2 Chequer Street
Pennfields, Wolverhampton
West Midlands
WV3 7DL
ENGLAND
Tel: (0) (+44) 1902 330489 or (0) (+44) 1902 337294
PaulH.
http://freespace.virgin.net/paul.hunt1/
-----Original Message-----
From: MGList <MG@sdlb.demon.co.uk>
To: mgs@autox.team.net <mgs@autox.team.net>
Date: 29 April 1999 12:21
Subject: Crown Wheel and Pinion, MGB GT V8
I am currently using the standard 1800 MGB rear axle which I believe has
a crown wheel and pinion ratio of 3.9:1. Unfortunately this does not
match the installed Rover V8 engine and gearbox which is best suited to
a much higher ratio, say 3.07:1. Does any know where I can obtain the
original spec MG V8 rear axle crown wheel and pinion for a reasonable
cost (£500+ seems a bit steep) . Are there any alternative rear axles
MGC, etc that can be used with modification if I want to retain the MG 4
stud wheels.
Andrew
|