Hi Bill,
I just replaced the u-joints on my 74B. Basically, you put the yoke/joint in a
vise so that you have access to the inner edge of the cap. Get a steel
chisel/screwdriver up against the edge and gently tap* the cap out. Use a good
penetrating oil (Kroil, PB Blaster) and lots of patience.
If the circlip is stuck you might tap the cap further in to get a little
clearance. Good luck.
*gently tap (as per the manual) really means use a 3 lb hammer and proceed to
beat
the snot out of it!
Have fun!
Gary
74B
|