Dave,
I've looked for that guy myself and have not been successful in locating it.
I believe the reason is that the later boxes were actually redesigned to
eliminate the need for this bushing by letting the sun gear run up against the
aluminum case. This has proved to be effective! Anyway, a couple of times
I've purchased an oil-lite bronze flanged bearing, turned it to fit the case,
pressed it into the case, then mill the flange face down to proper height. If
you don't have access to the type of equipment needed to do this operation,
any machine shop can do this for you, although it is probably going to cost
$50 - $75 to do so, depending upon shop rates, etc. Good luck!
Eric Swanger
Huntersville, NC
|