Simon Matthews wrote:
> Is it difficult to fit 3-point seatbelts in an 'A'?
The anchorage brackets for seat belts were fitted to the MkII's at
the factory. Todd Clarke of 'Clarke Spares & Restorations'
(1-215-348-0595) "... has reproduced the mounting hardware and
brackets to accommodate both the single point -one hole (as per
typical seat belt and brackets) and double point-two holes (as per
typcial BMC tonneau/wheel aarch seat belt end brackets)"
for the earlier models ... welding is required to fit the brackets.
Safety Fast! ... larry.g.unger@lmco.com
'61 MGA 1600 MkII
|