At 03:57 PM 10/7/97 +0000, Scott Gardner wrote:
>Well, I finally got around to going down to BAP today, and got the
>part number for the rounded rectangular filter for the Weber 32/36
>carb.
> It's made by EMPI, and the part number is 00-8842-0. I don't
>know if this is EMPI's part number or BAP's. BAP's number is
>800-633-0639, and the filter is about eight bucks.
>
> Also found a neat trick for the accelerator cable for the Weber
>32/36. I had frayed the end of mine that attaches to the throttle
>linkage, and the strands are so fine that it was impossible to get
>them all through the hole in the linkage. Also, when I tried to
>cut the frayed part off, the stands were so fine and springy that
>I couldn't get a clean cut without fraying the new end, giving me
>the same problem.
For future reference. When preparing to cut any stranded cable such as
choke and accelerator cables, some quick work with a soldering iron will be
a big help. Flow some solder into the strands in the area of the cut.
This will prevent fraying, and ease handling.
Regards,
Chris Delling
|