Not sure what you did wrong but this is the method to use. The MG
workshop manual, put out by MG identifies the part I am refering to making
as an engine sling. Victoria British sells it for $7.65. It's very
difficult to tip the engine enough unless you have a leveler (which Harbor
FFreight sells for $29.00)or lift it using the top studs.
...Art
On Fri, 12 Sep 1997, Ulix Goettsch wrote:
> This technique had no problem bending the valve cover stud on my A-series
> engine. I had to replace it.
>
> On Fri, 12 Sep 1997, Arthur Pfenninger wrote:
>
> > Attach an L shaped piece of metal to the cylinder head studs that
> > stick above the valve cover. Run a chain to connect the two L's together.
> > ...Art
> >
> > On Fri, 12 Sep 1997 Teacher122@aol.com wrote:
> >
> > > What are the lifting points on a B's 4 cylinder? I'll be putting mine
>back in
> > > a couple of weeks from now. Thanks!
> > >
> > > Tom Green
> > > 1979 MGB
> > >
> >
>
> Ulix __/__,__
> .......................................................... (_o____o_).....
> '67 Sprite
>
>
|