Having worn out at least 8 cam bearing tools, I can say that I have put in
my share of them, including Rover. Rovers are very easy, never had a fit
problem after installing a set. Not that it can't happen, but minor scraping
takes
care of it. If you borrow a tool, just make sure all the oil holes are in
the right place, they are well lubricated on the way in, and there is a good
chamfer at the leading edge of the hole. Test fit your cam before you have the
engine all back together, saves backing up. Dale
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|