5/8/04
James,
I have seen this build formula several times and in several places
over the years. What I haven't seen is specific information on the need
(or lack of need) for milling of piston head and/or cylinder head, to
control the C R. Please tell us what you did/didn't do and about what CR
you think you have, as a result. I sure would appreciate it.
----------------------------------------------------
>Carl,
> I stroked my 3.9 w/a 300 crank and used the Ford 255 pistons
>(cast). You'll probably have to get your cylinders honed a little and
>order the pistons oversized. D&D carries them, and they can probably be
>ordered from any Silv-o-lite distributor. I don't know if the deck
>hight will fork for your rods, though.
>James J.
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|