Larry Hoy wrote:
> Measure the distance between the transmission out put shaft and the flange
> on whatever rear diff you are using. Be sure to measure the length of the
> shaft too. Take the piece that fits your transmission and the one that
> fits the diff and your measurements to a drive shaft shop. That and a
> couple of hundred bucks will get you a drive shaft.
Larry's right. With a new driveshaft you get new u-joints as well. When I
called
a driveshaft place in town to get mine built, they made sure I knew to measure
the
distance while the car was on the ground and not hung on jack stands. That's a
little tricky but it can be done.
Larry-pictures on the way!!
--
Larry Dickstein
Lone Jack, MO
Pop. 420
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|