Simple - Cut the ends to a neat taper to fit into the aluminum, then carefully
round off the dome to a sloping contour on a belt sander.
Lawrie
> -------Original Message-------
> From: Richard Lindsay <richardolindsay@gmail.com>
> To: mg-t@autox.team.net
> Subject: [Mg-t] TD running board treads
> Sent: 08 Oct '15 05:42
>
> Hi Gang,
>
> The Moss-supplied rubber inserts for my TD's running board treads are
> not cut to fit. Rather, they are just strips of rubber. That means
> they don't fit the tapered ends of the metal strips. I have found that
> cutting the ends to fit results in pretty ugly results.
>
> What have you done to install these treads handsomely?
>
> -rick
> -------------------------
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/mg-t/lawrie@britcars.com
>
>
______________________________________________
Mg-t@autox.team.net
Archive: http://www.team.net/archive
|