It is all welded together and you cannot take it apart...The sender
is the small plate on the back and it won't do any good to remove it
other than protect it from the coating (if you need to)
You either have to fill it or take it off and slosh the fluid around
to coat it.
Mike
On Jun 28, 2008, at 12:03 PM, dhhall@bellsouth.net wrote:
> I would like to coat the inside of my MGTD gas tank with a
> protective coating (Red-Kote). The tank seems to be segmented
> inside. I'm not sure if I need to unscrew the plate on the lower
> back side to remove this. Excuse my ignorance, but is this some
> sort of gas gauge sender? If so, it certainly seems I should
> remove it. Any thoughts? Thanks in advance, David
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|