mg-t
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Mg-t] MG TF Dashboard Trim Rail Bolts

from [John Seim] [Permanent Link][Original]
To: MG <mg-t@autox.team.net>, mg-tabc@yahoogroups.com
Subject: [Mg-t] MG TF Dashboard Trim Rail Bolts
From: John Seim <kingseim@earthlink.net>
Date: Tue, 27 May 2008 09:01:24 -0700 
Anyone have a source of the retaining bolts for the MG TF Dash Board 
Trim Rail?
They were 1/4" BSF. The head was flat, with two prongs to grab into the 
wooden rail.

John Seim
Irvine, CA
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • [Mg-t] MG TF Dashboard Trim Rail Bolts, John Seim <=
Previous by Date:  Re: [Mg-t] 54 TF engine timing, Howard Battan
Next by Date:  [Mg-t] MG TD failed water pump shaft, William Putnam
Previous by Thread:  [Mg-t] Tune your SUs without leaving your desk, Douglas Ormrod
Next by Thread:  [Mg-t] MG TD failed water pump shaft, William Putnam
Indexes:  [Date] [Thread] [Top] [All Lists]