In a message dated 6/25/2005 9:31:39 AM Pacific Standard Time, yd3@nvc.net
writes:
> <<<snip>>>
> GM sells a product in their parts dept
> <<<snip>>>
> Years ago, mid 70's, my brother worked for a GM dealership. This had to be
> pre O2 sensor days. He used some sort of spray gunk to loosen frozen
> bolts. It was VERY good. As I recall had mostly a white label with black
> or blue printing. No eye candy pictures or graphics. Just a plain label.
> If the O2 sensor stuff is the same, it might even be better than PB Blaster
> I've used. Never tried Busty or Kroil as it's hard to find here. In fact
> PB Blaster just showed up in the last few years.
>
Hi Blake, folks were raving about Kroil some years ago so I ordered some and
its ok but not much better than WD40.....PB Blaster is better. I got up off
my butt and pulled out my can of Mr. Goodwrench "Rust Penetrant and inhibitor,
Heat valve Lube" Part no. 1052627. Besides a bunch of other deadly stuff, he
has Oleic acid, ammonium salt. It has worked in cases where I could not get
heat on the part.
Cheers,
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|