The seat slides attach to the bottom of the seats using 3/8x 32W screws;
eight (8) per seat. The slides are then attached to the floorboard. As
to the hinge for the seat back, the seat back should conform to the seat
cushion; the hinge more of a positioning and securing device to keep the
back attached to the bottom seat halves. With the seat slides placed in
the "full back" position, lay the seats and seat back on the
floorboards. This will then show where to drill two holes into each side
of the floorboard, since this is the farthest back that you could
possibly slide the seat. Should you require more leg length, contact C.
Cederstrand as to elevating the seats, for more support for the thigh
muscles.
|