John,
On the J2, I'm not certain of the finish on the ID plates. However, on my
PB, they were indeed flash plated with a thin coat of nickel (?).
Do help on the rest, I'm afraid. However, try Gary Krukowski
garykrukoski@yahoo.com
He had a lot of J2 parts he was selling. I don't know what he still has.
Cheers,
Lew Palmer
-----Original Message-----
From: owner-mg-mmm@Autox.Team.Net [mailto:owner-mg-mmm@Autox.Team.Net] On
Behalf Of Jorolibb@aol.com
Sent: Sunday, May 18, 2008 3:03 PM
To: mg-mmm@autox.team.net
Subject: J2 help needed
Folks,
Would someone confirm if the Guarantee plate and the lubrication plates on
the bulkhead and bulkhead supports were plain brass or were they silver
(nickel
plated)? Same question but the footbrake adjuster plate on the floor board.
Does anyone have a pattern for the windscreen glass that could be sent to
me?
This would be a windscreen with a vacuum type of wiper motor. Does anyone
supply the windscreen hardware such as the two lower corner brackets
including
screws plus all the screws for attaching the side supports to the windscreen
frame?
Does anyone have a set of body irons/sub frames for the body tub and/or any
of the other metal brackets/suppoorts that are inside the rear section of
the
tub that are surplus to their needs?
Best regards,
John Libbert
J2 3118
Milford, OH
**************Wondering what's for Dinner Tonight? Get new twists on family
favorites at AOL Food.
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
|