Re: MG PA Oil Leaks

["J.E.A. Rich" <mmmbob@adelphia.net>]

Dennis,

The front engine mount is easy to both remove and bore but to install  
a rear seal requires the flywheel housing to be removed as I have yet  
to find a seal that will fit without boring. The rear seal I use is  
50 x 58 x 4 mm, but  does require a few thou' to be milled out of the  
centre of the housing.

Cheers, "Bob".

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net