----- Original Message -----
From: "Elon Ormsby" <ormsby1@llnl.gov>
To: <land-speed@autox.team.net>
Sent: Monday, March 01, 2004 6:30 PM
Subject: Alternator pulley ratio
>>
> Since your set-up is pinion driven, the pinion rpm will never be
greater
> than engine rpm divided by your gear ratio.
Good so far.....if you're talking about transmission ratios....
(6,000 engine rpm /3.00 rear
> gear = 2000 pinion rpm). (assuming you transmission top gear is direct
or
But the pinion rpms are the same as tranny output rpms, with no
influence by the rear end ratio, eh?
Benn Karne
|