Re: Engine tools

[DOUG ODOM <popms@thegrid.net>]

        KT.... I only use my dial bore gage on bores that are too small to get
my hand into with an inside mike. I can read a quarter thousandth
difference with the inside mike and only one thousandth with the bore
gage. Just not the same feel.

Keith Turk wrote:
> 
> Well my Snap on guy was a bit short this year.... did find a Nice Snap- on
> Cam Bearing installer Set.... I had ordered one from Speedway but I
> cancelled it when they put it on back order...So now I have one thats LOTS
> nicer....
> 
> I'm missing a couple of pieces I would like to have to freshen my motors
> here at home.... Mostly a Dial bore gage.....  I have inside snap mic's but
> I really want a decent gage type set up.  I also need a quality Valve Spring
> pressure gage and Height checker...  Some where in here I gotta find a
> decent Valve spring compressor to remove them too....
> 
> Keith ( hey maybe someone had two of them laying around )

///
///  land-speed@autox.team.net mailing list
///  To unsubscribe send a plain text message to majordomo@autox.team.net
///  with nothing in it but
///
///     unsubscribe land-speed
///
///  or go to  http://www.team.net/cgi-bin/majorcool
///
///